Leaning Chimney? What It Means and What to Do
Published October 14, 2026 ยท More articles
You step back in the yard and something looks off: the chimney isn't quite straight anymore. Or there's a gap where it meets the siding. A leaning chimney is one of the few masonry problems that shouldn't wait.
Why a Lean Matters
A chimney is a tall, heavy stack of brick held together only by mortar. Once it starts to tip, its weight works against it. Mortar on one side gets crushed, mortar on the other side opens up, and the lean speeds up. Loose brick can fall onto the roof, the gangway or the neighbor's yard.
If the lean is new or obvious, keep people and cars out of the fall zone until it's inspected.
The Most Common Causes
1. Mortar failure above the roofline
Chicago's freeze-thaw cycles wash out and crack the mortar near the top of the chimney first. When enough joints fail on the weather side, the top section starts to tilt. This is the most common cause on older bungalows and two-flats.
2. A broken or missing crown
The crown is the concrete cap on top. When it cracks, water pours straight into the core of the chimney, freezes and pushes the brick apart from the inside.
3. Sulfate attack from flue gases
On older chimneys without a liner, acidic flue gases attack the mortar on the inside. That often shows up as a lean toward one side, usually the side facing the prevailing weather.
4. A settling footing
Exterior chimneys that run down the side of a house sit on their own footing. If that footing settles, the whole chimney tips away from the house and opens a gap at the wall.
Where Is It Leaning From?
- Only above the roofline: almost always mortar and crown failure. A rebuild from the roofline up is the usual fix.
- Whole chimney pulling away from the house: often a footing or foundation issue that needs closer evaluation.
- Bowing in the middle: the core of the chimney has deteriorated.
How a Leaning Chimney Gets Fixed
Mortar can't straighten a leaning chimney, so the leaning section comes down and gets rebuilt. A typical repair:
- Inspect the stack, crown, flashing and flue.
- Take the chimney down to sound, plumb brick.
- Relay it with matched brick and compatible mortar.
- Pour a new crown with a drip edge, add a cap, and re-flash it into the roof.
If the chimney isn't used, taking it down below the roofline and roofing over it is another option.
What You Can Do Today
- Look from the ground, not the roof, and take photos from a few angles.
- Check the attic and ceilings near the chimney for water stains.
- Note any brick pieces on the roof, in the gutters or on the ground.
- Don't use the fireplace until the chimney has been inspected.
Frequently Asked Questions
Can a leaning chimney be straightened?
Is a leaning chimney covered by insurance?
How fast can a lean get worse?
Stop Water Before It Gets Behind the Brick
Crumbling mortar lets water in, and Chicago's freeze-thaw winters do the rest. Tell us what you're seeing. Call (773) 389-2576 or send the form.
- Inspection first, with photos of what needs work
- Written estimate before anything starts
- Serving Chicago & Chicagoland
